Install radio frequency response device receiver – Turning Technologies TurningPoint User Manual
Page 120

TurningPoint for Office 2003 User Guide
120
Install Devices
Install Radio Frequency Response Device Receiver
The ResponseCards RF, XR, NXT and PresenterCard communicate with TurningPoint using a radio 
frequency. The receiver accepts the signal produced by the individual ResponseCards and passes the 
response to TurningPoint.
ResponseCard RF, ResponseCard XR, ResponseCard NXT and 
PresenterCard
Before You Begin
The receiver must be connected to the machine that will be used to run the presentation.
To install the radio frequency response device receiver…
1
Connect the device receiver to the USB port of the presentation computer.
Radio Frequency Response Device Receiver
Note
The effective range of most RF Receivers is about 200 
feet (60 meters) and the Long Range Receiver is 
about 400 feet (120 meters). A single receiver is 
sufficient for up to 1000 ResponseCards, and a direct 
line of sight between the receiver and the 
ResponseCard is not necessary.
Use more than one receiver during the presentation if 
the room size or participant size exceeds these 
maximum specifications. Contact Turning 
Technologies for suggested receiver layout plans.
