Turning Technologies AdjustIt 3 - Manual

AdjustIt 3 - Stand 1
ADJUSTIT 3 STAND
The AdjustIt3™ Stand provides a mobile solution to move from class to class and adjusts the height to accommodate all
users. Compatible with a wide range of short throw projectors, the mobile stand includes wheels with brakes for greater
stability.
WARNING
A minimum of two people are required to safely lift and mount the board to the stand.
What's in the Box?
(1) Right Column
(2) Horizontal Bar
(1) Left Column
Not pictured (12) M8x16 Screws
Not pictured (12) M8 Washer Plates
Not pictured (1) Hex Wrench
1 Place the right column on its side with brackets facing up.
2 Insert both horizontal bars over the brackets. Attach to the right column by inserting two screws with two
M8 washers into the pre-drilled holes on both horizontal bars. TIGHTEN EACH SCREW.
3 Carefully stand the right column.
4 Insert the horizontal bars into the left column brackets.
5 Insert two screws with two M8 washers into the pre-drilled holes on each Horizontal Bar and attach each bar to the
left column. TIGHTEN EACH SCREW.
6 Insert one screw and one M8 washer into each pre-drilled hole on the front of the stand.
DO NOT COMPLETELY TIGHTEN.
7 Attach the wall mount piece to the stand. TIGHTEN EACH SCREW.
turningtechnologies.com/user-guides