SurgeX SX-AX20 - Manual (Page 19)

Page 18
SX-AX15 (20) User Manual
VI. Command Line Interface (CLI) Protocol
(continued)
Device Commands (continued)
Command Description Admin Fact Def
set device <0 ‐16> Get / Set the device ID for cluster applications. Set a device ID of 0 for
single Axess applications. A device ID of 1 makes the unit a master,
and a device ID of 2-16 makes the unit a remote in cluster
configurations. These commands are only valid when directly
connected to the Axess, rather than as remote units in a cluster.
Yes 0
get device
set unit device <2 ‐16> Sets the ID of a remote
device in cluster
configurations. The
hardware key is
the last 2 bytes of the MAC
address with NO spaces,
dashes or colons.
In this example, the ey> is 38A2.
Yes
set factory defaults
Resets all parameters to their factory settings including the IP
Address. Only available on the serial port. Confirmation is required.
Note: This command can take up to 30 seconds to execute.
Yes
logout
Ends the session.
No
reboot
Reboots the selected Axess. This will not change the status of the
outlets of standalone or Master of cluster configuration (device ID 0 or
1). May cause outlet changes in expansion units (device ID 2-16).
Yes