4 channel update rate, Installation instructions – Spectrum Controls 140 ACI 052 00sc User Manual
Page 52
The following ladder logic shows how to move data from the 8 multiplexed
input words to a block of 32 output words starting at location 400101 using the
autosequence mode. This example file for use only with Modsoft programming
software can be formed on the install disk shipped with your module. The file
is under the A:\Programs subdirectory. To install:
1. Insert the install disk into drive A:
2. Copy A:\Programs\QAI32_GI.* C:\Modsoft\Programs
3. Select File QAI32_GI under Modsoft to run. The I/O map is as follows:
6.4 Channel Update Rate
The modules channel update rate is determined by the filter frequency selection.
A lower filter frequency takes longer to update each channel. The following
table shows the single channel update rate and 32 channel update rate for each
filter frequency.
46
Installation Instructions
32-Channel Analog Input Module
Quantum 140 ACI 052 00sc
Rack Slot Module Input Ref
Output Ref
Description
1 03 ACI 051 00SC 3000001-3000009 4000001-4000001 ACI05100 AN IN 32CH
300009
300009
300009
300009
300001
NCBT
NCBT
NCBT
NCBT
#00011
#00012
#00015
#00016
400101
BLKM
#00008
300009
300009
300009
300009
300001
NCBT
NCBT
NCBT
NOBT
#00011
#00012
#00015
#00016
400109
BLKM
#00008
300009
300009
300009
300009
300001
NCBT
NCBT
NOBT
NCBT
#00011
#00012
#00015
#00016
400117
BLKM
#00008
300009
300009
300009
300009
300001
NCBT
NCBT
NOBT
NOBT
#00011
#00012
#00015
#00016
400125
BLKM
#00008