Spectrum Controls 1746sc-NI8u User Manual
Page 26
14
SLC 500
™
Universal Analog Input Module
To insert your module into the rack, follow these steps:
1. Align the circuit board of your module with the card guides at the top
and bottom of the chassis.
Figure 2.1.
Module insertion into a rack
TB2
TB1
2. Slide your module into the chassis until both top and bottom retaining
clips are secure. Apply firm even pressure on your module to attach it
to its backplane connector. Never force your module into the slot.
Cover all unused slots with the Card Slot Filler, Allen-Bradley part number
1746-N2.
Terminal Block Removal
To remove the terminal block:
Using a screwdriver or needle-nose pliers, carefully unscrew and
then pry the terminal block loose. When removing or installing the
terminal block be careful not to damage the CJC sensors.