Pitney Bowes DP50S Color Printer User Manual
Page 176

4
4. Monitoring and Configuring the Printer
178
Message
Problem and solutions
Could not attach to PServer name> (In the remote printer mode) Connection to the Current Interface Speed: Speed of the Ehternet interface (10Mbps, 100 Current IPX address Current IPX address DHCPv6 server not found. The DHCPv6 server was not found. Make sure Duplicate IP= dress>). The same IP address (IPv4, or IPv6 address) Established SPX Connection with PServer , (RPSocket= (In the remote printer mode) Connection to the Exit pserver (In the print server mode) The print server Frametype= The frame type name is configured to be used on IEEE 802.11 Displays Wireless LAN communication mode IEEE 802.11 Card does NOT support WPA . A wireless card that does not support WPA isin- IEEE 802.11 Card Firmware REV. Displays the version number of the 802.11 card’sfirmware. IEEE 802.11 current channel Displays the current channel number of the activewireless card (in ad hoc and infrastructure mode). IEEE 802.11 MAC Address = Displays the MAC address of the wireless inter- face.
printserver has not been established. The print
serverhas refused the connection. Check the
print serverconfiguration.
Mbps, or 1Gbps).
thatthe DHCPv6 is on the network.
wasused. Each IP address (IPv4, or IPv6 ad-
dress) mustbe unique. Check the address of the
deviceindicated in
printserver has been established.
functionis disabled because the necessary print
serversettings have not been made.
NetWare.
(infrastructure, or 802.11 ad hoc).
stalled. Install a wireless card that supports WPA.