Pitney Bowes DP50S Color Printer - Manual (Page 174)

4
4. Monitoring and Configuring the Printer
Message List
This is a list of messages that appear in the printer’s system log. The system log can be viewed
using the “syslog” command.
System Log Information
Use the following command to display the system log information:
• UNIX: Use the “syslog” command and “rsh”, “rcp”, “ftp”, and “sftp” parameters.
• telnet: Use the “syslog” command.
176
Message Problem and solutions
Access to NetWare server name>denied. Either there is no account for this
print serveron the NetWare server on the pass-
word wasincorrect.
(In the print server mode) Login to the file server-
failed. Make sure that the print server is regis-
teredon the file server. If a password is specified
for theprint server, delete it.
account is unavailable: encryption is impossible.
Encryption is not possible and account is dis-
abled.
This could be because:
• Security option is not installed.
• Encryption password has not been specified.
account is unavailable: same account name
beused. User account is disabled. This could be because
ituses the same account name as the administra-
toraccount.
account is unavailable: The authenticationpass-
word is not set up. User account is disabled. This could be because
theauthentication password is not set, and only
theencryption account is set.
add_sess_IPv4: bad trap addr:address>,community:
The IPv4 address (0.0.0.0.) is unavailable when
thecommunity access type is TRAP. Specify the
host
IPv4 address for the TRAP destination.
add_sess_IPv4: communityname>already defined. The same community name already exists. Use-
another community name.
add_sess_IPv6: bad trap addr:address>,community: The IPv6 address [::] is unavailable when the-
community access type is TRAP. Specify the host
IPv6 address for the TRAP destination.