Martin Christ Alpha 1-2 LDplus - Manual (Page 40)

Freeze-dryer Alpha 1-2 LDplus
6 Operation
40
Version 11/2006, Rev. 2.0 of 02/12/2014 • sb
Translation of the original operating manual
Pos: 122 /20 0 Ch rist/3 60 G T-BA L abo r-Pilot (STANDARDMODU LE)/0 60 Bet rieb/ LDplus/ 060 -00 50- 002 0 Mod us @ 31\ mod_ 140 835 250 197 8_6 8.docx @ 2 095 63 @ 3 @ 1
6.5.2 Mode
The mode can be called up with the left function key if a value window is
active. The individual phases can be selected as follows:
• Press the left function key "mode". The menu "Start with phase..." will
be displayed (see the illustration).
• Select the desired menu item by way of the up/down keys.
• Confirm with the right function key "enter".
Fig. 22: Selecting a mode
Starting the freeze-drying process
The freeze-drying process comprises four phases:
• Freezing
• Warm-up vacuum pump
• Main drying
• Final drying
If "main drying" or "final drying" is selected, the system enquires as to
whether the vacuum pump shall warm up beforehand.
Changing the phase
The freeze-dryer is in the run mode. In order to switch over to the next
phase or to stop the process by way of "standby":
• Press the left function key "mode". The menu "Select mode" will be
displayed (see the illustration).
Fig. 23: Selecting a mode
• Select the menu item "Continue with phase..." by way of the up/down
keys and confirm the selection with the right function key "enter".
• Select the desired phase by way of the up/down keys and confirm the
selection with the right function key "enter".
Fig. 24: Continuing the freeze-drying process