Elenco Deluxe Digital / Analog Trainer with Tools Kit Version - Manual (Page 47)

-46-
FINAL ASSEMBLY
r Fasten the front panel in
place with four #6 x 3/8”
thread cutting screws, as
shown in Figure I.
r Fasten the PC board to
the spacer on the front
panel with a fiber washer
and a 4-40 x 1/4” screw
(from Power Supply
Section) from the foil side
of the PC board, in the
location shown in Figure J.
r Fasten the pots to the
front panel with an 8mm
washer and a 7mm nut, as
shown in Figure I.
r Turn the shafts on the two
switches fully counter-
clockwise. Push the knobs
onto the shafts so that the
line on the knob is in line
with the “Squarewave” on
the waveform control and
“10” on the Coarse
Frequency control (see
Figure K).
If the knobs are loose on
the shafts, insert a
screwdriver into the slot
and expand the slot
slightly (see Figure M).
r Turn the shafts on the pots fully counter-clockwise. Push the knobs onto the shafts so that the line on the
knob is in line with the end of the circle on the front panel, as shown in Figure L.
If the knobs are loose on the shafts, insert a screwdriver into the slot and expand the slot slightly (see Figure M).
Knobs
Nut 7mm
Nuts 7mm
Washers 8mm
Washer 8mm
#6 x 3/8” Thread
cutting screws
#6 x 3/8” Thread
cutting screws
Figure I
Washers 9mm
Nuts 8mm
Figure J
4-40 x 1/4” Screw
Figure M
10
100 1k 10k
100k
Figure K
WAVE FORM COARSE FREQ
Figure L
Fiber washer