Elenco Deluxe Digital / Analog Trainer with Tools Kit Version - Manual (Page 14)

MOUNT COMPONENTS TO PANEL
r Push the illuminated switch into the hole in the top
panel with the lugs as shown in Figure V.
r Install the fuse holder with the side lug in the position
shown in Figure V. Fasten the fuse holder in place with
the nut as shown in Figure V. Unscrew the cap and
insert the fuse into the holder.
r There is a raised area on the back side of the top
panel. Screw the spacer to the raised area by inserting
a 4-40 x 1/4” flat head screw into the hole in the raised
area from the top side of the panel (see Figure W).
r When mounting the breadboard, use the holes shown
in Figure X. Mount the breadboard with two #4 x 1/4”
AB black screws from the back side of the top panel as
shown in Figure W. The negative (blue) stripe should
be on top and the numbers reading from left to right
should start with number 1 (see Figure Y). CAUTION:
Do not remove the paper backing from the back of
the breadboards. Do not over-tighten the black
screws.
Figure X
-13-
Spacer
4-40 x 1/4”
Flat head
screw
Top panel
Breadboard
#4 x 1/4” AB screws
Figure W
a
e
b
c
d
f
j
g
h
i
1 5 10
Figure Y
Back Side - Lower
Right Corner
Figure V
Side lug
Illuminated switch
Top panel
Plastic washer
Fuse holder
Nut