Display Devices Lifts up up 35 lbs - Manual (Page 9)

IP025-001 V3
IBL Lift Series Installation
07/05 Thor/Sales Info/Installation Materials/IBL Lift 9
PHYSICAL INSTALLATION
SIDE-MOUNTING
Side-mounting is typically used when installing the IBL-1522 lift between 16” on-center
floor joists.
NOTE for Retrofit installations with the IBL-1522:
Cut hole opening – 21”l x 14.5”w.
1.)
Determine the top height of lift/enclosure and mark the top position on the
joists. Mark the front and rear position of the lift on the joists – both the left and
right sides.
2.) For installations which need the plenum enclosure, attach the plenum enclosure
to the 8 studs on the lift’s upper frame. Add flat washer, split lock washer and
7/16” nuts – tighten. Retrofit installations in sheetrock ceilings often require the
plenum enclosure to be removed.
3.) Determine the best location for power, control and signal cables to enter the lift
enclosure. Use a knockout tool or drill holes in the enclosure for cables. We
recommend using flex conduit to the enclosure.
4.)
Install the four mounting brackets to the floor joists using ¼” x 1 ¼” lag screws
and washers. The brackets mount to the joist.
6.)
Raise the lift into position between the mounting brackets. Attach lift to
mounting brackets reinstalling the ¼”x 20 bolts. Do not tighten yet.
NOTE for Retrofit installations: Raise the lift on an angle – get one end of the lift
above the sheetrock, then lift the opposite end up above the ceiling. Level and attach
mounting brackets reinstalling the ¼”x 20 bolts. Do not tighten yet.
Mounting Bracket
Mounting Bracket bolts