Display Devices Lifts up up 35 lbs - Manual (Page 17)

IP025-001 V3
IBL Lift Series Installation
07/05 Thor/Sales Info/Installation Materials/IBL Lift 17
Final Adjustments
Operate the lift up and down several times to verify all adjustments and ensure proper
operation.
Raise the lift to its home position with the UP button (in MANUAL mode) slowly,
carefully, and intermittently. Observe the cables rigged to the sides of the lift carefully
and watch for any problems.
Bring the lift down with the DOWN button, and again watch for any problems. Adjust
the closure system as needed.
Operate the lift up and down several times.
Place the lift in automatic mode. (OVERRIDE + STOP).
If you did not set the 12-volt trigger and AC configuration revisit Part 1 and set the Dip
Switches for your system design.
The lift is now installed and ready for operation.
Specifications
IBL1522 100 lbs. combined weight – projector, lens, plenum
and ceiling closure
IBL2424 107 lbs. combined weight – projector, lens, plenum
and ceiling closure
IBL6060 107 lbs. combined weight – projector, lens, plenum
and ceiling closure
Operating Temperature Range
32° – 104°F / 0° – 40°C
Horsepower 1/15 – 110V60Hz or 220V 50Hz
Current Draw 2.0A @ 110V
1.0A @ 220V