ADLINK CoreModule 435 - Manual (Page 50)

Chapter 4 BIOS Setup
44 Reference Manual CoreModule 435
• Quiet Boot – [Disabled; Enabled]
• Add On ROM Display Mode – [Force BIOS; Keep Current]
• Bootup Num-Lock – [Off; On]
• PS/2 Mouse Support – [Disabled; Enabled; Auto]
• Wait for 'F1' If Error – [Disabled; Enabled]
• Hit 'DEL' Message Display – [Disabled; Enabled]
• Interrupt 19 Capture – [Disabled; Enabled]
• Boot From LAN – [Disabled; Used INT 18h; Used INT 19h; PnP/BEV (BBS); RPL]
• Beep Function – [Disabled; Enabled]
• OnBoard Virtual Flash FDD – [Disabled; Enabled; Diskette Write Protect]
BIOS Security Setup Screen
Figure 4-5. BIOS Security Setup Screen
• Supervisor Password – [Not Installed]
• User Password – [Not Installed]
• Change Supervisor Password
a. Select Change Supervisor Password from the Security Setup menu.
b. Press to access the pop-up entry field, Enter New Password.
c. Type the password and press again.
The screen will not display the password as you type.
BIOS Setup Utility
Security Settings
Select Screen
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
v02.xx (C) Copyright 1985-20xx, American Megatrends, Inc.
Supervisor Password : Not installed
User Password :Not installed
Change Supervisor Password
Change User Password
Boot Sector Virus Protection [Disabled]
Main Advanced PCIPnP Boot Security Chipset Exit
CM435_BIOS_SecurityScreen_a