ADLINK IMB-S90 - Manual (Page 85)

IMB-S90 IPMI User’s Manual
85
3.7.22 Virtual Media
In MegaRAC GUI, this page to configure Virtual Media device settings. If you change the
configuration of the virtual media in this page, it shows the appropriate device in the
JViewer Vmedia dialog. For example, if you select two floppy devices in Configure Virtual
Media page, then in JViewer > Vmedia, you can view two floppy device panel.
To open Virtual Media page, click Configuration > Virtual Media from the menu bar. A
sample screenshot of Virtual Media Page is shown below.
Configure Virtual Media Devices
The following fields are displayed in this page.
Floppy devices: The number of floppy devices that support for Virtual Media redirection.
CD/DVD devices: The number of CD/DVD devices that support for Virtual Media
redirection.
Harddisk devices: The number of harddisk devices that support for Virtual Media
redirection.
Disable Power Save Mode: To enable or disable the virtual USB devices visibility in the
host.
Save: To save the configured settings.
Reset: To reset the previously-saved values.
3.7.22.1 Procedure
1. Select the number of Floppy devices, CD/DVD devices and Harddisk devices
from the drop-down list
Note: Maximum of two devices can be added in Floppy, CD/DVD and Harddisk
drives.
2. Check the option Disable Power Save Mode to disable the virtual USB devices
visibility in the host machine.
3. Click Save to save the changes made else click Reset to reset the previously saved
values.