ADLINK IMB-S90 - Manual (Page 116)

IMB-S90 IPMI User’s Manual
116
3.11.2 Image Transfer Protocol
This page is used to configure the firmware image protocol information.
To open Image Transfer Protocol page, click Firmware Update > Protocol Configuration
from the menu bar. A sample screenshot of Image Transfer Protocol page is shown
below.
Image Transfer Protocol
The various options of Image Transfer Protocol are given below.
Protocol Type: To transfer the firmware image into the BMC.
Server Address: Server IP address of the firmware image is stored.
Note:
• IP Address made of 4 numbers separated by dots as in “xxx.xxx.xxx.xxx”.
• Each number ranges from 0 to 255.
• First number must not be 0.
Source Path: Full Source path with filename of the firmware image is stored.
Retry Count: Number of time(s) to be retried when transfer failure occurs. Retry count
ranges from 0 to 255.
Save: To save the configured settings.
Reset: To reset the modified changes.
3.11.2.1 Procedure
1. Select the Protocol Type from the drop-down list.
2. If the protocol selected is TFTP, enter the IP address of the server in the Server
Address field.
3. Enter the Source Path in the given field.