ADLINK ETX-PVR User Manual
Page 46

Chapter 3
Hardware
40
Reference Manual
ETX-PVR
44
PIDE_INTRQ Primary Drive Interrupt Request (IRQ 14) – Asserted by drive when it has
pending interrupt (PIO transfer of data to or from the drive to the host).
45 NC
Not
Connected
46
PIDE_AK*
Primary DMA Channel Acknowledge – Used by the host to acknowledge
data has been accepted or data is available. Used in response to
PIDE_DMARQ when asserted.
47 NC
Not
Connected
48
PIDE_RDY
Primary I/O Channel Ready – When negated extends the host transfer cycle
of any host register access when the drive is not ready to respond to a data
transfer request. High impedance if asserted.
49,
50
VCC
DC Power – +5 volts +/-5%
51 NC
Not
Connected
52
PIDE_IOR*
Primary Drive I/O Read – Primary strobe signal for read functions. Negative
edge enables data from a register or data port of the drive onto the host data
bus. Positive edge latches data at the host.
53 NC
Not
Connected
54
PIDE_IOW*
Primary Drive I/O Write – Primary strobe signal for write functions. Negative
edge enables data from a register or data port of the drive onto the host data
bus. Positive edge latches data at the host.
55 NC
Not
Connected
56
PIDE_DRQ
Primary DMA Request – Used for DMA transfers between host and drive
(direction of transfer controlled by IOR* and IOW*). Also used in an
asynchronous mode with ACK*. Drive asserts an IRQ when ready to transfer
or receive data.
57 NC
Not
Connected
58
PIDE_D15
Primary Disk Data 15 – These signals (0 to 15) provide the Primary IDE disk
data signals.
59 NC
Not
Connected
60
PIDE_D0
Primary Disk Data 0 – Refer to J4, pin-58 for more information.
61 NC
Not
Connected
62
PIDE_D14
Primary Disk Data 14 – Refer to J4, pin-58 for more information.
63 NC
Not
Connected
64
PIDE_D1
Primary Disk Data 1 – Refer to J4, pin-58 for more information.
65,
66
GND
Ground
67 NC
Not
Connected
68
PIDE_D13
Primary Disk Data 13 – Refer to J4, pin-58 for more information.
69 NC
Not
Connected
70
PIDE_D2
Primary Disk Data 2 – Refer to J4, pin-58 for more information.
71 NC
Not
Connected
72
PIDE_D12
Primary Disk Data 12 – Refer to J4, pin-58 for more information.
73 NC
Not
Connected
74
PIDE_D3
Primary Disk Data 3 – Refer to J4, pin-58 for more information.
Table 3-8. Complete X4 Interface Pin Signal Descriptions (J4) (Continued)