ADLINK Express-CBR - Manual (Page 32)

Chapter 3 Hardware
28 Reference Manual Express-CBR
COM Express C-D Connector
The COM Express C-D connector is a 220-pin connector providing the following features:
• IDE interface
• PCI interface
• PCI Express Graphics (PEG) interface
• SDVO functionality
IDE Interface
The JMD330 controller provides a fast IDE interface that supports two IDE devices, including IDE hard
drives and ATAPI devices with independent timings. The IDE interface supports PIO IDE transfers up to 16
MB/second, Ultra DMA transfers up to 133 MB/second, and employs DASP (Drive Active Slave Present)
signals.
PCI Interface
The PCI bus complies with PCI specification Rev. 2.3 and provides a 32-bit parallel PCI bus that is capable
of operating at 33MHz.
PCI Express Graphics (PEG)
The Express-CBR supports the implementation of a x8 link for an external high-performance PCI Express
Graphics card. It supports a theoretical bandwidth of up to 4GB/s. Each lane of the PEG Port consists of a
receive and transmit differential signal pair designated from PEG_RX8 (+ and -) to PEG_RX15 (+ and -)
and correspondingly from PEG_TX8 (+ and -) to PEG_TX15 (+ and -).
A94 RSVD B94 VGA_VSYNC
A95 RSVD B95 VGA_I2C_CK (PU 2.2k 3.3V)
A96 GND B96 VGA_I2C_DAT (PU 2.2k 3.3V)
A97 VCC_12V (Not Connected) B97 TV_DAC_A (SPI_CS1 for Carrier)
A98 VCC_12V (Not Connected) B98 TV_DAC_B (Not Connected)
A99 VCC_12V (Not Connected) B99 TV_DAC_C (Not Connected)
A100 GND B100 GND
A101 VCC_12V (Not Connected) B101 VCC_12V (Not Connected)
A102 VCC_12V (Not Connected) B102 VCC_12V (Not Connected)
A103 VCC_12V (Not Connected) B103 VCC_12V (Not Connected)
A104 VCC_12V B104 VCC_12V
A105 VCC_12V B105 VCC_12V
A106 VCC_12V B106 VCC_12V
A107 VCC_12V B107 VCC_12V
A108 VCC_12V B108 VCC_12V
A109 VCC_12V B109 VCC_12V
A110 GND B110 GND
Table 3-5. COM Express A-B Connector Signal Descriptions (Continued)