ADLINK aTCA-6200A - Manual (Page 65)

65
Network Stack
This option is used for enabling or disabling UEFI network stack for onboard Ethernet.
Ipv4 PXE Support
This option is used for enable Ipv4 PXE boot support. If disabled IPV4 PXE boot option will
not be created.
Ipv6 PXE Support
This option is used for enable Ipv6 PXE boot support. If disabled IPV4 PXE boot option will
not be created.
The Network stack PXE boot supports EFI boot only.
IPv6 Delay Time
This option is used for set seconds of delay before IPv6 PXE boot.
6.3.11 iSCSI Configuration
You can use this screen to specify options for the iSCSI settings, The screen is shown as
below.
if you want to use iSCSI function, you have to enable Network Stack function first, and
the iSCSI function provided here is for EFI boot only.
iSCSI Initiator Name
You can use this option to set iSCSI initiator name, only IQN format is accepted.