ADLINK aTCA-6200A - Manual (Page 18)

18
3.1.5 Silicon Motion SM750 Graphics Controller
The aTCA-6200 provides an analog VGA port on the front panel powered by Silicon Motion SM750 2D
graphics controller with the following features:
•
PCI-Express x1 architecture
•
16MB integrated video DDR memory
•
Low power consumption < 1.5W
•
300 MHz DAC supports up to 1920x1440 resolution
•
128-bit 2D graphic engine
•
ROPs, BitBLT, transparent BLT, pattern BLT, Color expansion, and Line drawing
•
YUV-16/32-bit RGB conversion
• Support 7 layers of display frames (2 hardware cursors, primary graphic, video, video alpha, alpha,
and secondary graphic)
•
Two 8-bit portsorone16-bitvideocaptureportsupportsITU601
•
and ITU 656 specifications UV-16/32-bit RGB conversion
•
ReduceOnTM Power Management Technology
• Quick-Rotation features allow for 90°, 180°, and 270° rotation of on-screen images
3.2 Peripherals
The following standard peripherals are available on the aTCA-6200 blad
3.2.1 Battery
The aTCA-6200 is equipped with a 3.0 V “coin cell” lithium battery for the RTC. To replace the
battery, proceed as follows:
„ Turn off power
„ Remove the battery
„ Place the new battery in the socket
Make sure that you insert the battery with the correct orientation. The positive pole must be on the
top.
The lithium battery must be replaced with an identical battery or a battery type recommended by the
manufacturer. A suitable battery is the Panasonic CR2032.
Note: The user must be aware that the battery’s operational temperature range is less than that of the
aTCA-6200’s storage temperature range. For exact temperature range information, refer to the battery
manufacturer’s specifications.
Note: Care must be taken to ensure that the battery is correctly replaced. The battery should be
replaced only with an identical or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions. The typical life expectancy of a 225mAh battery