D-Link DES-3326S - Manual (Page 199)

DES-3326S Layer 3 Fast Ethernet Switch User’s Guide
Web-Based Switch Management 199
Entering the show stacking command with no parameters
returns all of the relevant stacking information for all of the
switches in the stack:
Figure 6-19. Console CLI show stack Command
The same switch stack information is displayed in the console
as is displayed in the Web-based management agent.
The config stack command allows you to configure the switch
stack manually.
The syntax of the config stacking command is as follows:
config stacking mode
[auto/master/slave/standalone]
One of the parameters auto/master/slave/standalone must
be entered along with the config stacking mode command.
These parameters have the following effects:
auto Switches in the stack will be assigned a unit ID
sing a comparison of the numerical value of the