Aiwa Z-L70 - Manual (Page 6)

REMOTE CONTR BEFORE OPERATION
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
The maximum operationai distance between the remote controi
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
►/◄►PRESET on the remote control
The function is the same as that of ◄► on the main unit.
If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possibie
eiectrolyte leakage.
' The remote control may not operate correctly when:
- The line of sight between the remote controi and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controis are used nearby (those of a television,
etc.)
CD
To turn the power on
Press one of the function buttons (TAPE, TUNER, PHONO,
VIDEO/AUX or CD).
Piayback of the inserted disc or tape begins, or the previousiy
tuned station is received (Direct Piay Function).
POWER is aiso available.
To turn the power off
Press POWER.
Illumination guides
Whenever POWER or one of the function buttons is pressed,
the buttons for the selected operation iight up or fiash.
Examp/e;When CLOCK is pressed, IISET, ◄◄ and ►► fiash
as a guide to setting the current time.
Flash windows
The window on the top of the unit and the cassette decks light
up or flash while the unit's power is on.
To turn off the light of the top window, press ICLEAR while
pressing CD. To turn back on, repeat the above.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as weii.
To change the brightness level of the display
1 Press ECO so that “ECO MODE” is displayed.
2 Within 4 seconds, turn MULTI JOG to display “DIM MODE”,
and then press ENTER within 4 seconds.
3 Within 4 seconds, turn MULTI JOG to select the dimmer mode
as below.
The mode will be automatically set after 4 seconds. It will
also be set if ENTER is pressed within 4 seconds after step
3.
-DIM-OFFDIMMER 1-wDIMMER 2 DIMMER 3 -
c □
DIM-OFF: The normal display.
DIMMER 1: The illumination of the display is dimmer than
usual.
DIMMER 2: The illumination of the display is dimmer than
DIMMER 1.
DIMMER 3: The illumination of the display is dimmer than
DIMMER 2. The spectrum analyzer, the window on the top of
the unit, and the button lamps light off.
ENGLISH