Aiwa Z-L70 - Manual (Page 27)

OTHER CONNECTIONS
-CD DIGITAL OUT
(OPTICAL)
■ VIDEO/AUX IN
SURROUND
SPEAKERS
Refer to the operating instructions of the connected equipment
for details.
• The connecting cords are not suppiied. Obtain the necessary
connecting cords.
• Consuit your iocal Aiwa deaier for optional equipment.
VIDEO/AUX IN JACKS
This unit can input anaiog sound signais through these jacks.
Use a cabie with RCA phono piugs to connect audio equipment
(LD piayer, VCR, TV, etc.)
Connect the red piug to VIDEO/AUX R jack, and the white plug
to VIDEO/AUX L jack.
CD DIGITAL OUT (OPTICAL) JACK
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (DAT
deck, MD recorder, etc.)
Remove the dust cap @ from CD DIGITAL OUT (OPTICAL)
jack, then connect an optical cable plug to CD DIGITAL OUT
(OPTICAL) jack.
POWER
To play equipment connected to the VIDEO/AUX IN jacks,
proceed as follows:
1 Press VIDEO/AUX.
“VIDEO” appears on the display.
2 Play the connected equipment.
To change a source name on the display
When VIDEO/AUX is pressed, “VIDEO” is displayed initially. It
can be changed to “AUX" or “TV”.
With the power on, press POWER while pressing VIDEO/AUX.
Repeat the procedure to select one of the names.
To adjust the sound level of equipment connected to the
VIDEO/AUX IN jacks
When the sound level of the external source is much higher or
much lower than that of other function sources, adjust it as
follows.
1 Press VIDEO/AUX and play the equipment.
2 Press or ►► until the sound level becomes the same
as that of other function sources.
NOTE
During recording, the sound level can not be adjusted.
a
III
S
H
o
z
<
ij
0
111
ij
n
1
z
a
3
m
z
o
o
III
o
u
K
111
z
H
o
When CD DIGITAL OUT (OPTICAL) jack is not being used
Attach the supplied dust cap.
SURROUND SPEAKERS JACKS
Connect optional surround speakers with 8 ohms to 16 ohms
impedance to the jacks.
ENGLISH
27