Aiwa Z-L70 - Manual (Page 21)

PROGRAMMED EDIT RECORDING
Selected disc
number Program number
ri 1 -­
'ft 0 ip^;
Selected track number
Remaining time on side A
Programmed track numbers
2
8
6 Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press CD EDIT/CHECK to select side B and
program the tracks for side B.
Alter confirming B on the display, repeat step 5.
Tape side B (reverse side)
""1
^................
p........ : > 0 « №
i w
In the programmed edit recording function, the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
NOTE
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
Use the remote control from steps 3 to 8.
1 Insert the tape into Deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press CD and load the disc(s).
8 Press #/OREC/REC MUTE and then press
within 2 seconds to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side A ends, recording on
the back side B starts.
To stop recording
Press Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK to select side A or B,
and press ◄◄ or ►► repeatedly.
Disc number Program number
“PRGM EDIT” and “PRGM’ light up on the display.
PRGM PRGM EDIT H H :
•rV" - - -
PR !;;/n
ilÜi
■•-■■ft
«.4») ,
®=1||
1,
When “Al” is displayed, press CD EDIT/CHECK again.
4 Press the numbered buttons 0-9 to designate the
tape length.
10 to 99 minutes can be specified.
Maximum recording
Tape length time for side A
ftftHPiC....... bv;
V
0....... 130
Tape side(A)
5 Press DISC DIRECT PLAY, then press one of the
numbered buttons 1-5 within 3 seconds to select
a disc. Then, press the numbered buttons 0-9
and +10 to program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY and 2, then +10 and 0.
O
z
oe
o
o
ill
oe
Track number Programmed track numbers
To change the program of each side
Press CD EDIT/CHECK to select side A or B, and press
■ CLEAR to clear the program on the selected side. Then
program tracks again.
To clear the edit program
Press ■ CLEAR twice so that “EDIT” disappears on the display.
NOTE
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
ENGLISH
21