When an fm stereo broadcast contains noise, To change the am tuning interval, Rune – Aiwa Z-L70 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

RADIO RECEPTION
■MONO
TUNER
1 PressTUNER/BAND to select the FM or AM band.
When TUNER/BAND is pressed while the power is off, the
power is turned on directly (Direct Play Function).
2 Press TUNER PRESET repeatedly to select the
manual tuning mode.
Each time the button is pressed, the following three tuning
modes are selected cyclically.
® Preset tuning mode; The preset number flashes.
(DAuto search mode: “SEARCH” is displayed.
©Manual tuning mode: “SEARCH" is not displayed and
the preset number does not flash.
Frequency SEARCH
.11
NOTE
" I
Preset number
The preset tuning mode is skipped if no station is preset.
Turn MULTI JOG clockwise or counter-clockwise
to tune in to a station.
The frequency changes as you turn MULTI JOG. When a
station is received, “TUNE" is displayed for 2 seconds.
During FM stereo reception, (n®il) is displayed.
(IIODII)
rUNE
To search for a station quickly (Auto Search)
Press TUNER PRESET repeatedly to display “SEARCH” (auto
q
search
mode),
and
turn
MULTI
JOG
clockwise
or
z
counterclockwise until the frequency starts to change rapidly. 3
After tuning in to a station, the search stops.
§
SEARCH
...... '
W”
To stop the Auto Search manually, turn MULTI JOG a little in
either direction.
• The Auto Search may not stop at stations with very weak
signals.
• ◄◄DOWN and ►►UP are also available to search for a
station. Keep ◄◄DOWN or ►►UP pressed until the tuner
starts searching. Press the button to stop the search manually.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control so that “MONO”
appears on the display.
Noise is reduced, although reception is monaural.
MONO
H
a
u
o
u
B
o
<
B
I
To restore stereo reception, press MONO TUNER so that
“MONO” disappears and “STEREO” is displayed for 2 seconds.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing ◄►on the unit.
To reset the interval, repeat this procedure.
(DOWN and ►•►UP are also available to tune in to a
station.
ENGLISH
11