Aiwa Z-L70 - Manual (Page 26)

TURNTABLE
5 Adjust the volume.
The source sound will play at the volume level set in this step
when the power is turned on by the timer.
If the volume level is set to 21 or higher, however, it will
automatically be set to 20 when the power is turned on.
6 Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape. Insert the tape into Deck 1 or 2.
To listen to the radio, tune In to a station.
7 Press POWER to turn off the power.
© remains on the display after the power is turned off (timer
standby mode) if the power-economizing mode is OFF.
©
I-U11 0 ^ 3-..;
BASIC OPERATION
I
2,4
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
NOTE
• You can change the source that was selected in step 1 by
pressing one of the function buttons before pressing ENTER
or II in step 3.
• If the power-economizing mode is ON, © is not displayed in
the timer standby mode.
To check the timer setting
Press TiMER.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 4 seconds.
To change any of the previous setting
Carry out from step 1.
Fiowever, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel the timer standby mode temporarily
Press TIMER repeatedly until © disappears and “ijOFF” is
displayed.
To restore the timer standby mode, press TIMER once or twice
to display © or ©REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 and 6.
Preparation
• Connect the supplied stereo turntable to the main unit. (See
page 4)
• Set EQUALIZER AMP. selector on the turntable to ON position.
(Refer to the operating instructions of the turntable for details.)
1 Press PHONO on the main unit.
“PFIONO” appears on the display.
2 Adjust the volume to minimum.
Turn VOLUME counterclockwise until “VOL 00” is displayed.
3 Play the turntable.
Refer to the operating instructions of the turntable for details.
4 Adjust the volume according to your preference.
NOTE
' Timer playback and timer recording will not begin unless the
power is turned off.
■ Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press TiMER repeatedly until ©REC appears on the
display, then press ENTER within 6 seconds.
Carry out the steps of “SETTING THE TIMER” from step 3 and
insert the tape to be recorded on into Deck 2 after step 6.
26
ENGLISH