beautypg.com

Precautions, Owner’s record, Warning – Aiwa CX-NA30 User Manual

Page 2

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC

SHOCK. DO NOT EXPOSE THIS APPLIANCE TO

RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

PRECAUTIONS

“CAUTION:TO REDUCE THE RISK OF

ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.”

Expliiiicition of GrnphiCc'il Symbols:

The lightning flash with arrowhcaa symbol,
within an cquilaloral thanglo. is intondod !o
ainrt the user to the iv-esencc of uninsulaied
“dangerous voltage” within the product’s en­
closure that may be of sutticient magnitude to
constitute a risk of electric shock to persons.

The exclamation point within an equilateral
triangle is intended to alert the user to the

presence of important operating and mainte­
nance (servicing) instructions n the hioraturo

accompanying the appliance.

Owner’s record

For your convenience, record the model number and serial
number (you will find them on the rear of your set) In the space
provided below. Please refer to them when you contact your

Aiwa dealer in case of difficulty.

Model No.

Serial No. (Lot No.)

CX-NA30

SX-NA34

SX-R210 (NSX-A35 only)

Read the Operating Instructions carefully and completely before

operating the unit. Be sure to keep the Operating Instructions
for future reference. All warnings and cautions in the Operating

Instructions and on the unit should be strictly followed, as well

as the safety suggestions below.

Installation

1

Water and moisture

— Do not use this unit near water, such

as near a bathtub, washbowl, swimming pool, or the like.

2

Heat

— Do not use this unit near sources of heat, including

heating vents, stoves, or other appliances that generate heat.
It also should not be placed in temperatures less than 5°C
(41 °F) or greater than 35°C (95°F).

3

Mounting surface

— Place the unit on a flat, even surface.

4 Ventilation —

The unit should be situated with adequate

space around it so that proper heat ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and the top of the

unit, and 5 cm (2 in.) from each side.
- Do not place the unit on a bed, rug, or similar surface that

may block the ventilation openings.

- Do not install the unit in a bookcase, cabinet, or airtight rack

where ventilation may be impeded.

5 Objects and liquid entry

— Take care that objects or liquids

do not get inside the unit through the ventilation openings.

6 Carts and stands

— When

placed or mounted on a stand
or cart, the unit should be moved
with care.
Quick stops, excessive force,
and uneven surfaces may cause
the unit or cart to overturn or fall.

7 Condensation

— Moisture may form on the CD pickup lens

when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function

normally. Should this occur, leave the unit for a few hours,

then try to operate again.

8 Wall or ceiling mounting —

The unit should not be mounted

on a wall or ceiling, unless specified in the Operating

Instructions.

Electric Power

1

Power sources

— Connect this unit only to power sources

specified in the Operating Instructions, and as marked on the

unit.

2

Polarization

— As a safety feature, some units are equipped

with polarized AC power plugs which can only be inserted

one way into a power outlet. If it is difficult or impossible to

insert the AC power plug into an outlet, turn the plug over and

try again. If it still does not easily insert into the outlet, please

call a qualified service technician to service or replace the
outlet. To avoid defeating the safety feature of the polarized

plug, do not force it into a power outlet.

3 AC power cord

- When disconnecting the AC power cord, pull it out by the

AC power plug. Do not pull the cord itself.

- Never handle the AC power plug with wet hands, as this

could result in fire or shock.

- Power cords should be firmly secured to avoid being severely

bent, pinched, or walked upon. Pay particular attention to
the cord from the unit to the power socket.

- Avoid overloading AC power plugs and extension cords

beyond their capacity, as this could result in fire or shock.

1

ENGLISH