Aiwa CX-NA30 - Manual (Page 16)

MICROPHONE MIXING
KARAOKE■
A microphone (not supplied) can be connected to this unit,
allowing you to sing along to music sources.
Use a microphone with mini plugs (03.5 mm, Vs inch).
1 Connect your microphone to the MIC jack.
MIC
2 Press one of the function buttons to seiect the
source to be mixed, and piay the source.
3 Adjust the voiume and tone of the source.
4 Turn the MIC VOL controi to adjust the
microphone voiume.
To record microphone sound mixed with source sound
Follow the procedure for recording from the sound source (see
page 11). . .
The SYNCHRO DUBBING button cannot be used for mixing
recording.
When not using the microphone
Set the microphone volume to MIN and remove the microphones
from the MIC jack.
• If a microphone is held too near the speakers, a howling sound
may be produced. In this case, hold the microphone away
from the speakers, or decrease the microphone volume.
• If sound through the microphone is extremely loud, it may be
distorted. In this case, decrease the microphone volume.
Recommended microphones
The use of unidirectional type microphone is recommended to
prevent howling. Contact your local Aiwa dealer for details.
VOCAL FADER/MULTIPLEX FUNCTIONS
This unit can use discs or tapes as Karaoke sources.
Press the KARAOKE button repeatedly to select the vocal
fader or multiplex function.
Use the vocal fader function for ordinary discs or tapes.
Use the multiplex function for multi audio discs or tapes;
Each time the KARAOKE button is pressed, one of these
functions is selected cyclically. '
©
ii'f
■
© Vocal Fader
The singer’s voice becomes softer than the accompaniment.
@ Auto Vocal Fader
The singer’s voice becomes softer only while there is audio
input through a microphone.
® Multiplex
Only the sound on the left channel is heard from both
speakers, and the sound on the right channel is muted.
0 Auto Multiplex
The sound on the left channel is heard from both speakers,
and the sound on the right channel is muted only while there
is audio input through a microphone. '
©Cancel
To change the time lag setting in Auto Vocal Fader or
Auto Multiplex function
The muted original singer’s voice can be turned faster to the
normal level.
When Auto Vocal Fader or Auto Multiplex is selected, “A-VF” or
“AUTO MPX” is displayed for 3 seconds and changes to the
selected function name. After the selected function name is
displayed, hold down the KARAOKE button until FAST is
displayed.
'
To return to the initial setting, select SLOW.
When the power is turned off, SLOW is restored.
To change the audible channel in Multiplex function
Only the sound on the right channel can be heard from both
speakers.
When Multiplex is selected, “MPX L-ch” is displayed for 3 seconds
and changes to the selected function name. After the selected
function name is displayed, hold down the KARAOKE button
until MPX-R is displayed. "
To return to the initial setting, select MPX-L.
When the power is turned off, MPX-L is restored.
• The Karaoke functions may not operate correctly with the
following kinds of CDs or tapes.
- Those with monaural sound
- Those recorded with strong echoes
- Those with the vocal part recorded on the right or left side of
the sound width
•While the Karaoke function Is on, the sound is output as
monaural.
15
ENGLISH