Aiwa CX-NA30 - Manual (Page 10)

- ' ■« !: ■ ■;: .:■ i ¡ T
■ ■■' y- ■!*'■.'•■■ -•■■t-ii-.v—:«?
.. '-r ' ■ .ViY-
BASIC OPERATIONS
LOADING DISCS
Press the CD button, then press the — OPEN/
CLOSE button to open the disc compartment. Load
disc(s) with the iabei side up.
To play one or two discs, place the discs on tray 1 and 2.
To play three discs, press the DISC CHANGE button to rotate
the trays after placing two discs. Place the third disc on tray 3.
Close the disc compartment by pressing the ± OPEN/CLOSE
button.
Tray
DISC CHANGE
Tray number of the
disc to be played Total playing time
I
6-Z)
■' U
■ ! ! !■ : :
: -j- o : d i f 3 .1 i
Total number of tracks
PLAYING DISCS
Load discs.
To play all discs in the disc compartment, press the
► button.
Play begins with the disc on tray 1.
Elapsed playing time
-a
I
Number of track
being played
To play one disc only, press one of the DISC DIRECT
PLAY buttons.
The selected disc is played once.
To stop play, press the ■ button.
To pause play, press the II button. To resume play, press again.
To search for a particular point during playback, keep the
◄◄ or ►► button pressed and release the button at the desired
point.
To skip to the beginning of a track during playback, press
the ◄◄ or ►► button repeatedly.
To remove discs, press the ± OPEN/CLOSE button.
To start play when the power is off (Direct Play Function)
Press the CD button. The power is turned on and play of the
loaded disc(s) begins.
To replace discs before play, press the £ OPEN/CLOSE button
to open the disc compartment.
To check the remaining time
During play, press the EDIT/CHECK button on the remote control
while pressing the SHIFT botton. The amount of time remaining
until all tracks finish playing is displayed. To restore the play
time display, repeat the above again.
Selecting a track with the remote control
1 Press one of the DISC DIRECT PLAY buttons to select a disc.
2 Press the numbered buttons and the +10 button to select a
track.
Example:
To select the 25th track, press the +10, +10 and 5 buttons.
To select the 10th track, press the +10 and 0 buttons.
The selected track starts to play and continues to the end of
that disc.
Replacing discs during play
While one disc is playing, the other discs can be replaced without
interrupting play.
1 Press the DISC CHANGE button.
2 Remove the discs and replace with other discs.
3 Press the £ OPEN/CLOSE button to close the disc
compartment.
' When loading an 8-cm (3-inch) disc, put it onto the inner circle
of the tray.
' Do not place more than one compact disc on one disc tray.
■ Do not tilt the unit with discs loaded. Doing so may cause
malfunctions.
9
ENGLISH