CBM America CBM-262 User Manual
Page 90
7
81
(45) Sending the printer status (ESC v)
Code: [1B] h + [76] h + n
This command sends the current printer status.
•
The status sent is 1 byte. The contents are as shown in the following table.
•
In the case of DTS/DSR control, after confirming that the host is ready to receive
(the DSR signal is High), one byte only is sent. In the case of XON/XOFF control,
one byte only is sent without confirming the status of the DSR signal.
•
In the case of DTR/DSR control, if the host is not ready to receive (the DSR signal
is Low), it waits until the host is ready to receive.
Bit
Function
Value
0
1
0
Journal near end sensor
Paper present
No paper
1
Receipt near end sensor
Paper present
No paper
2
Journal near end sensor
Paper present
No paper
3
Receipt end sensor
Paper present
No paper
4
Not used
Fixed at 0
5
Downloading of character
No downloading
Downloading
6
Downloading of bit image
No downloading
Downloading
7
Not used
Fixed at 0
[Note]
This is valid only with the Serial interface.
Input Data Format