CBM America CBM-262 - Manual (Page 74)

7
65
(19) Controlling data input (ESC = n)
Code: [1B] h + [3D] h + n
* (0
n FF) Data are expressed in Hex code.
• Each bit of n is as shown in the following table.
Bit Function
Value
0 1
0 Printer Disable Enable
1 Not defined
2 Not defined
3 Not defined
4 Not defined
5 Not defined
6 Not defined
7 Not defined
• If the printer is not selected, all the data received are destroyed until the printer is
selected by this command.
• Even if the printer is not selected, the printer may, according to its operation, enter
the BUSY state.
• The initial value is “n = 1”.
(20) Erasing download characters (ESC ? n)
Code: [1B] h + [3F] h + n
* (20
n 7E) Data are expressed in Hex code.
The download characters with the specified code are erased.
•
n indicates the character code that erases the definition pattern. After erasure,
printing of the same patter as internal characters is done.
• The specified code definition patters of character fonts selected by ESC ! are erased.
• If the specified character code is not defined, this command is disregarded.
Input Data Format