CBM America CBM-262 - Manual (Page 85)

7
Chapter 7 Print Control Codes
76
(35) Selecting the setting sheet (ESC c 1 n)
Code: [1B] h + [63] h + [31] h + n
* (1
n 3) Data are expressed in Hex code.
Selects the sheet which is the object of line feed settings set by ESC 2 and ESC 3.
•
Each bit of n is as shown in the following table.
• If the value of n deviates from the definition range, this command is disregarded.
• The initial value is “n = 3”.
(36) Selecting an effective paper end sensor for outputting the
paper end signal (ESC c 3 n)
Code: [1B] h + [63] h + [33] h + n
* (0
n FF) Data are expressed in Hex code.
Selects which state of which sensor for outputting to the Centronics parallel interface
PE signal.
• The initial value is “n = 3”.
[Note] This is valid for the parallel interface only.
Bit Function
Value
0 1
0 Journal Disable Enable
1 Receipt Disable Enable
2 Not defined
3 Not defined
4 Not defined
5 Not defined
6 Not defined
7 Not defined
Bit Function
Value
0 1
0 Journal Near End Sensor Disable Enable
1 Receipt Near End Sensor Disable Enable
2 Journal End Sensor Disable Enable
3 Receipt End Sensor Disable Enable
4 Not defined
5 Not defined
6 Not defined
7 Not defined