CBM America CBM-262 - Manual (Page 86)

7
77
(37) Selecting the paper snd sensor that is effective for
stopping printing (ESC c 4 n)
Code: [1B] h + [63] h + [34] h + n
* (0
n FF) Data are expressed in Hex code.
Selects which paper end sensor will stop printing.
• Even if the sensor which has been enabled senses the paper end, if printing of that
sheet is disabled, printing will not stop.
• If multiple sensors have been specified as enabled, printing will stop when any one
of the sensors detects the paper end.
• If printing is stopped, the print operation actually stops after the current line has
been printed and paper feed has been completed.
• If paper end is detected by the journal or receipt sensor, the printer goes off-line
after printing stops.
• The initial value is the state specified in the menu setting.
(38) Enabling/Disabling the panel switch (ESC c 5 n)
Code: [1B] h + [63] h + [35] h + n
* (0
n FF) Data are expressed in Hex code.
This command enables or disables the paper feed key (Receipt/Journal key).
•
In n, the least significant bit (n0) becomes enabled.
• The least significant bit (n0) is as follows.
n0 = 0: Enables the paper feed key.
n0 = 1: Disables the paper feed key.
• The paper feed key is enabled regardless of this setting when the cover is open.
• The initial value is “n0 = 0”.
Bit Function
Value
0 1
0 Journal Near End Sensor Disable Enable
1 Receipt Near End Sensor Disable Enable
2 Not defined
3 Not defined
4 Not defined
5 Not defined
6 Not defined
7 Not defined
Input Data Format