CBM America CBM-262 User Manual
Page 65
7
Chapter 7
Print Control Codes
56
Bit
Function
Value
0
1
0
Character Font
Font A
Font B
1
Not defined
2
Not defined
3
Bold
Clear
Specify
4
Vertical double
Clear
Specify
enlargement
5
Horizontal double
Clear
Specify
enlargement
6
Not defined
7
Underline
Clear
Specify
(11) Specifying the print mode all at once (ESC ! n)
Code: [1B] h + [21] h + n
* (0
n
FF) Data are expressed in Hex code.
This command specifies the print mode.
•
Each bit of n is as shown in the following table.
•
If both vertical and horizontal double enlargement are specified at the same time,
quadruple enlargement characters can be configured.
•
Underlines are applied to all the characters printed, but portions skipped with a
horizontal tab (HT) and portions with characters which are rotated 90 degrees to
the right are not underlined.
•
The underline width is the width set in ESC _ with no relation to the character size.
•
Mixed printing with double enlarged characters, and with characters of different
sizes, is possible.
•
Character sizes can also be specified by GS !, but the command that is set last is the
one that is valid.
•
The initial value is “n = 0”.