CBM America CBM-262 - Manual (Page 87)

7
Chapter 7 Print Control Codes
78
(39) Print and feed paper n lines (ESC d n)
Code: [1B] h + [64] h + n
* (0
n FF) Data are expressed in Hex code.
This command prints the data in the print buffer and feeds the paper n lines.
•
The set amount does not remain.
• The next printing start position is the head of the line.
• If the paper feed amount exceeds 40 inches, paper feeding of 40 inches only is
executed.
(40) Full cut (ESC l)
Code: [1B] h + [69] h
Executes a full cut of the receipt paper.
•
This command is valid only if it is input at the head of a line.
(41) Partial cut (ESC m)
Code: [1B] h + [6D] h
Executes a partial cut (one point is left) of the receipt paper.
•
This command is valid only if it is input at the head of a line.
(42) Generates a specification pulse (ESC p m n1 n2)
Code: [1B] h + [70] h + m + n1 + n2
* (0
n1 FF)
(0 n2 FF) Data are expressed in Hex code.
This command outputs the signals specified in n1 and n2 to connector pin m.
•
The m bit (m0) is as follows.
m0 = 0: Drawer kick No. 2 pin
m0 = 1: Drawer kick No. 5 pin
• On time is n1 x 2 ms and Off time is n2 x 2 ms.
• If n2 is smaller than n1, Off time is made n1 x 2 ms.