ClearOne AP800 - Manual (Page 60)

Appendices ~ Appendix F: Serial Commands 56
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
PP
This command changes or reports back the state of the
phantom power for a microphone.
[DEVICE] PP
Explanation
CH= 1-8 Parameter to apply to the specified
microphone channel
CH= * Parameter to apply command to all
microphone channels
X=0 Parameter to set the state to OFF
X=1 Parameter to set the state to ON
X=Null Parameter to return the current state
Return Values
The command will return the updated condition (On=1,
Off=0) of the phantom power in the same format as the
command.
PRESET
This command selects or reports the current preset
configuration used by the AP800.
[DEVICE] PRESET
Explanation
X=1-6 Sets the preset to the number specified
X=Null Parameter to return the current preset
Return Values
The command will return the current preset (updated, if the
command changed the preset).
REFSEL
This command selects or returns the output to be used as the EC
Reference 1 and EC Reference 2.
[DEVICE] REFSEL
Explanation
X=1 Parameter to select the EC Reference 1
X=2 Parameter to select the EC Reference 2
X=3 Parameter to select the G-Link EC Ref bus
OUTPUT=1-8 Parameter to select 1-8 as the EC reference
OUTPUT=A-D Parameter to select A-D as the EC reference
OUTPUT=E Parameter to select G-Link EC Ref bus as the
EC Reference
OUTPUT=F Parameter to select none
OUTPUT=Null Parameter to return the EC reference value
Return Values
Command returns the updated condition of the reference select in
the same format as the command.
TOUT
This command sets or reports the current inactivity timeout before
returning to the title screen used by the unit.
[DEVICE] TOUT
Explanation
X=0 Disables inactivity timeout
X=1-15 Sets the number of minutes specified
X=Null Parameter to return the current number of minutes
Return Values
The command will return the current timeout value (updated, if
the command changed the timeout).