ClearOne AP800 - Manual (Page 45)

41
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Appendices ~ Appendix F: Serial Commands
AAMB
This command changes or reports back the state of the adaptive
ambient for a microphone.
[DEVICE] AAMB
Explanation
CH= 1-8 Parameter to apply to the specified microphone
channel
CH= * Parameter to apply command to all microphone
channels
X=0 Parameter to set the state to OFF
X=1 Parameter to set the state to ON
X=Null Parameter to return the current state
Return Values
The command will return the updated condition (On=1, Off=0)
of the adaptive ambient in the same format as the command.
For serial port command protocol and syntax, see pages
39-40.
AGC
This command changes or reports back the state of the AGC for
a microphone or line input.
[DEVICE] AGC
Explanation
CH= 1-8 Parameter to apply to the specified mic
channel
CH= A-D Parameter to apply to the specified line
input
CH= * Parameter to apply command to all mic
channels
X=0 Parameter to set the state to OFF
X=1 Parameter to set the state to ON
X=2 Parameter to toggle the state from one state to
the other (regardless of current state)
X=Null Parameter to return the current state
Return Values
The command will return the updated condition (On=1, Off=0)
of the AGC in the same format as the command.
AMBLVL
This command changes or reports back the setting of the fixed
ambient level for each AP800. This value is only used if
adaptive ambient is not enabled.
[DEVICE] AMBLVL
Explanation
X=0 to -70 Parameter to set the ambient level (in dB)
X=Null Parameter to return the ambient level
Return Values
The command will return the updated ambient level for the
selected AP800 in the same format as the command.