ClearOne AP800 - Manual (Page 35)

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
When operating the AP800, there should be very little to do with the AP800 unit
itself. You can make changes quickly with AP-Ware software, if necessary. If
correctly installed and programmed, the AP800 system should not require any
further interface other than perhaps controlling volume of a particular output, or
muting an input or output.
Remote Control
ClearOne Communications recommends use of a custom remote controller for user
interface. Refer to the manufacturer’s documentation for your particular custom
remote controller. Basic control is also available with the ClearOne AP IR Remote.
All other functionality requiring direct interface with the equipment is
contained in other parts of the Audio Perfect system, such as the AP10, or is
handled through the serial port.
Volume Control
To increase volume
1. Determine which output (speaker, telephone, etc.) the input audio
(microphones, CD player, etc.) is being routed to.
2. Press the Outputs, scroll to the Gain Adjust selection, then press Enter.
To decrease volume
1. Adjust the gain level with the s and t buttons. You should be able to hear the
volume level adjust while increasing or decreasing the gain.
2. When the desired level is reached, press Enter.
CHAPTER 4: Operation
Control