ClearOne AP800 - Manual (Page 12)

The AP800 is designed for easy installation and setup. All connections are made
through rear-panel connectors. This chapter provides instructions on installing the
units and making initial connections, creating a G-Link network, assigning device ID
numbers, selecting the mixer mode, and using the LCD menu.
The diagram below illustrates the typical connections that are made for a
single-unit AP800 system. The default routing settings in AP-Ware allow the
AP800 to work out of the box for this type of installation.
Connecting the unit
To connect the AP800
1. Place the unit in a standard 19-inch rack and attach it securely.
2. If you are using a custom controller for control and status, connect it to the
Control/Status port [G].
Installation ~ Installation 8
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Tape Player (Optional)
Control System
or PC (Optional)
Speakers
External Power Amp
Logic Out
Status and
Control
Telephone
Set
AP10
Analog Telephone Line
AP800
G-Link
Terminator
G-Link
Terminator
Video
CODEC
REMOTE TRANSMIT INPUT RECEIVE
OUTPUT G-LINK IN OUT
TEL CO LI NE SET
V OLTAGE RANGE 100v-240V 2A FREQUENCY 50Hz/60Hz
Hardware Setup
Figure 2.1. Completed AP800 installation
A B
C
D E F G
Figure 2.2. Rear Panel Connectors