ClearOne AP800 - Manual (Page 52)

Appendices ~ Appendix F: Serial Commands 48
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
MDMODE
This command enables or disables the modem mode for the
AP800. When the modem mode is enabled, the modem
initialization string is sent out the serial port and the serial
port now requires a password before a command is processed.
Note: The default password is a carriage return (enter). If the
password is forgotten, it can be cleared back to a carriage
return via the front panel.
INACTIVITY NOTE:
After five minutes of serial inactivity, the password will be
requested to continue serial activity.
[DEVICE] MDMODE
Explanation
X=0 Sets modem mode to OFF
X=1 Sets modem mode to ON
Return Values
The command will return the updated condition (1=On, 0=Off)
of the pin in the same format as the command.
MEQ
This command changes or reports back the state of the
equalizer adjustment for a microphone input.
[DEVICE] MEQ
Explanation
CH= 1-8 Parameter to apply to the specified microphone
channel
CH= * Parameter to apply command to all microphone
channels
BAND=H, M, L Parameter to select which band is
modified
X=-12 –12 Parameter to set level of the band
X=Null Parameter to return the current level
Return Values
The command will return the updated condition of the equalizer
in the same format as the command.