Inserting a bobbin – SINGER 5160 User Manual

Page 40

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

S I N G E R

Inserting a bobbin

DO NOT FORGET TO SWITCH OFF THE AAACHINE

WHILE WORKING IN THE BOBBIN AREA.

1. Lift presser foot.

2. Turn hand wheel toward your direction until

needle is in its highest position.

Pull approximately 4” of thread from repla

cement bobbin and insert bobbin into case

(illustration 1).

Note: While unwinding, the thread should turn from

right to left (counter clockwise).

4. Holding bobbin in place, guide thread into slot A

(illustration2).

5. Guide the thread down the slot to the left around

to slot B (illustrations).

6. Close the bobbin visor partially allowing some

thread to come up and toward the back

(illustration 4).