SINGER 5160 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

S I N G E R
5. Pass thread end through bobbin winder tension disc
(illustration 4).
6. Pass thread end, from inside through small hole in
rim of bobbin.
7. Slide bobbin winder pin to the left. Place bobbin in
the bobbin winder pin and push it to the right
(illustration 5).
8. Holding up thread end upwards (illustration 6), step
on foot speed control pedal to run machine.
9. After a couple of turns, stop the machine and trim
thread end near the hole. Continue to wind the
bobbin. The bobbin will automatically stop when it
is full.
10. Trim the thread, push the bobbin to the left and
remove from the pin (illustration 7).
11. Press the bobbin winding indent to its original
position. If necessary, turn the hand wheel until it
locks (illustration 8).
36
- 401A (116 pages)
- Simple 3116 (94 pages)
- 1507 (88 pages)
- 1507WC (88 pages)
- 112W140 (32 pages)
- 147-2 (30 pages)
- 114-33 (43 pages)
- 119-3 (23 pages)
- 14K1 (10 pages)
- 147-104 (34 pages)
- 116-1 (20 pages)
- 115-2 (38 pages)
- 14U286 (40 pages)
- 14U286B (21 pages)
- 114-4 (29 pages)
- 142W25 (10 pages)
- 147-81 (28 pages)
- 118 (16 pages)
- 136W105 (22 pages)
- 114-41 (20 pages)
- 147-4 (28 pages)
- 105-3 (30 pages)
- 1027 (36 pages)
- 147-26 (37 pages)
- 12W208 (25 pages)
- 128-4 (25 pages)
- 109-320 (14 pages)
- CP17 (47 pages)
- 147-6 (56 pages)
- 132B26 (9 pages)
- 114-2 (36 pages)
- 1371A3 (86 pages)
- 14CG754 (53 pages)
- 147-50 (39 pages)
- 14T967DC (3 pages)
- 109-520 (13 pages)
- 14SH654 ULTRALOCK (48 pages)
- 147-86 (30 pages)
- 105-20 (23 pages)
- W303 (13 pages)
- 147-38 (53 pages)
- 114-22 (45 pages)
- 1375A1 (33 pages)
- 107-2 (31 pages)
- 1200A (4 pages)