Removing the shank, Changing a needle – SINGER 5160 User Manual

Page 26

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

S I N G E R

Removing the shank

TURN OFF THE A^ACHINE BEFORE REMOVING THE

SHANK.

1. Turn hand wheel until the needle is in its highest

position and lift the presser foot.

2. Loosen the screw "A" and remove the shank pulling it

down.

3. To replace the shank "B" fit it around the presser bar

and tighten screw'A".

Changing a needle

TURN OFF THE A^ACHINE BEFORE CHANGING

NEEDLE.

1. Turn hand wheel until the needle is in its highest

position.

2. Loosen the needle clamp screw and remove needle.

3. With the flat side of needle to the back, insert new

needle up into clamp as far as it will go.

4. Tighten needle clamp screw firmly.