Sears 831.15934 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
4.
Attach fhe Sect (28} to the Upright (9) with the two
1
/4" X
3/4' Bolts (20) and o 1 /4' x 2 1 /2' Bolt
(46).
15. Center one Pod Tube (22) in the Upright (9), ond the
other Pad Tube in the Leg Developer (23). Slide the
four Smoll Pods (17) onto the ends of the Pod Tubes.
1
6.
Rest the Left and Right Pedals (75, 76} on the hoolcs
ot the lower ends of the Resistance Cylinders (84).
Make sure that the hooks are fully inserted Inb the
same slots under both Pedals.
Plug the Transformer (39) into the jack located neor
the bottom of the Right Side Shield (12).
17. Moke sure that oil ports ore properly tightened. The use of oil remaining ports will be explained In ADJUSTING
THE CROSS TRAINER e, beginning on page 8 of this owner's manual.
18. Before using the CROSS TRAINER e, test the cables and the pulleys. Moke sure that the cobles are In the grooves
in the pulleys, if the cables do not move smoothly over the pulleys, locate and correct the problem before using
the CROSS TRAINER e. If the'cables are not properly routed, they will be damaged when used.
7