Trouble-shooting and maintenance – Sears 831.15934 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ATTACHING THE lAT BAR, ROWER BAR OR

STRAP TO THE LOW PULLEY STATION

Cable

clip (33).

For some exercises, jfie Chain

(38)

should be ortocKed between the Lot Bar ond the

Main Cable with two Coble Clips. Adjust the length

of the Chain between the Lat Bor and the Main

Cable so the Lot Bar is in the correct starting posi

tion for the exercise to be performed.

The Rower Bor (34) or the Strop (35) can be

offoched in the some manner.

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all ports eoch lime you use the CROSS TRAINER e. Replace any worn ports immediately. Outside

surfaces of the CROSS TRAINER e con be cleaned using a damp cloth and mild detergent. Keep oil liquids away from

the stepper console and the PERSONAL TRAINER computer.

Most CROSS TRAINER e problems can be solved by following the steps below. Find ihe applicable symptom and follow

the step(s) listed. If further ossistonce is needed, coll our Customer Service Deportment toll-free of 1 -800-999-3755,

Monday through Friday, d a.m. until

p.m. Mountoin Time (excluding holidays).

SYMPTOM: THE POWER DOES NOT TURN ON

Maice sure thot ihe transformer is fully plugged into the jock on the CROSS TRAINER e, ond into o 120-volt outlet.

SYMPTOM; THE MAIN CABLE DOES NOT MOVE SMOOTHLY, OR THERE IS SLACK IN THE MAIN CABLE

Inspect the rouh'ng of the cables and moke sure thot they ore in the grooves in all of the pulleys. If they

ore

not,

correct the problem. If the cables are not properly routed, they will be damaged when used.

b. If there is slack in the Main Coble (51), locate the

Adjustment Brocket (53) near the bottom of the

right side shield. Hold the end of the Weight

Coble (52) firmly, and slide the Adjustment

Bracket forther onto (he Weight Coble. Tighten

the 5/16" Nut (82) against the Adjustment

Bracket. Test the Main Cable. If the motor stolls

or hesifofes, loosen the 5/16“ Nut slightly. If the

5/16" Nut is tightened os for os possible ond

there is still slack, the Main Cable should be

reploced. See ORDERING REPIACEMENT PARTS

on the back cover of this owner's manual.