Bobbin winding (continued) – Sears 38512102 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bobbin Winding (continued)
Q Push the bobbin to the right,
[
7
] With free end of the thread held in your hand,
depress the foot control. Stop the machine
when it has made a few turns, and cut the thread
dose to the hoie in the bobbin.
[|] Depress the foot control again. When the bobbin
is fully wound, it stops automatically. Return the
bobbin winder to its ortginaf position by moving
the spindle to the left and cut the thread as shown.
I Push the handwheel to the left to engage dutch.
*The machine does not function until the clutch is
it
v5l »t Jf!lt I Fit J .
NOTE: Position of the bobbin winder stopper is
adjustable for the required amount of thread
on bobbin (example 1/2 fuil or full etc.).
Use a screwdriver and loosen the screw one
tum or less to adjust the position of the bobbin
winder stopper.
Do not take out the screw all the way,
18