Sears 38512102 - Manual (Page 2)

IMPORTANT SAFETY INSTRUCTIONS
Your sewing machine is designed and constructed only for HOUSEHOLD use.
Read aJI instructions before using this sewing machine
DANGER
■ To reduce the risk of electric shock:
1. This sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the
electric outlet immediately after using and before cleaning.
2. Always unplug before replacing a sewing machine bulb. Replace bulb with same type rated 15 Watts.
3. Do not reach for a sewing machine that has fallen into water. Unplug immediately,
4. Do not place or store this sewing machine where it can fail or be pulled into a tub or sink. Do not place or drop it into water
or other liquid.
WARNING
To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Do not allow this sewing machine to be used as a toy. Close attention is necessary when this sewing machine is used by
or near children,
2. Use this sewing machine only for its intended use as described in this owner’s manual.
Use only attachments recommended by the manufactureras contained in this owner’s manual
3. Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or dropped into water.
Return this sewing machine to the nearest Sears store or service center for examination, repair, electrical or mechanical
adjustment.
Never operate this sewing machine with any air opening blocked. Keep ventilation openings of this sewing machine and
foot controller free from accumulation of iint, dust and loose doth.
Never drop or insert any object into any opening.
Do not use outdoors,
Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
8. To disconnect, turn alt controls to the off (" Q “) position, then remove plug from outlet,
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away from all moving parts. Special care is required around the sewing machine needle.
11. Always use the proper needle plate . 1Tte wrong plate can cause the needle to break,
12. Do not use bent needles.
13. Do not pull or push fabric white stitching. It may deflect the needle causing it to break.
14. Switch this sewing machine off (" Q") when making any adjustment in the needle area, such as threading the needle,
changing the needle, threading the bobbin or changing the presser foot, and the like,
15. Always unplug this sewing machine from the electrical outlet when removing covers, lubricating, or when making any
other adjustments mentioned in this owner's manual.
4,
5,
6,
7.
SAVE THESE INSTRUCTIONS
When using your sewing machine for the first few times, place a waste fabric under the presser foot and run
the machine without thread for a few minutes. Wipe away any oil which may appear.