Bobbin winding, Removing bobbin case – Sears 38512102 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bobbin Winding
® Removing bobbin case
Remove the extension table from the machine by pulling it to
the left. Open the shuttle cover (Dby pulling down the
embossed part on the left of the cover.
Raise the needle to its highest position by rotating the
handwheel toward you.
(D Shuttle cover
@ Bobbin case
To remove the bobbin case (g) from the shuttle, pull open the
latch of the bobbin case. Pull the bobbin case straight out of
the shiittie,
® Bobbin winding
[j] Release the clutch by pulling out the handwheel. This
will stop the needle from moving while you wind the
bobbin.
[H Draw thread from spool.
lU Guide the thread around the thread guide.
m Thread through the hole In the bobbin from the inside to
the outside,
H]
Put the bobbin on the bobbin winder spindle.
16