Cabletron Systems SmartSwitch - Manual (Page 77)

SmartSwitch Router User Reference Manual 77
Chapter 5: DHCP Configuration Guide
To define the parameters that the DHCP server gives the clients, enter the following
command in Configure mode:
Configuring a Static IP Address
To define a static IP address that the DHCP server can assign to a client with a specific
MAC address, enter the following command in Configure mode:
Grouping Scopes with a Common Interface
You can apply several scopes to the same physical interface. For example, scopes can
define address pools on different subnets that all are accessed through the same SSR port.
In this case, scopes that use the same interface must be grouped together into a
“superscope.”
To attach a scope to a superscope, enter the following command in Configure mode:
netbios-name-server IP address of NetBIOS Name Server (WINS server)
netbios-node-type NetBIOS node type of the client
netbios-scope NetBIOS scope of the client
Define client parameters. dhcp define parameters
...
Table 3. Client Parameters
Parameter Value
Define static IP address for a
particular MAC address. dhcp define static-ip
mac-address [
...]
Attach a scope to a superscope. dhcp attach superscope