Cabletron Systems SmartSwitch User Manual
Page 64
Chapter 3: Bridging Configuration Guide
64
SmartSwitch Router User Reference Manual
•
Define the Maximum Idle Interval
Adjusting the Interval between Hello Times
You can specify the interval between hello time.
To adjust this interval, enter the following command in Configure mode:
Defining the Forward Delay Interval
The forward delay interval is the amount of time spent listening for topology change
information after an interface has been activated for bridging and before forwarding
actually begins.
To change the default interval setting, enter the following command in Configure mode:
Defining the Maximum Age
If a bridge does not hear BPDUs from the root bridge within a specified interval, it
assumes that the network has changed and recomputes the spanning-tree topology.
To change the default interval setting, enter the following command in Configure mode:
Specify the interval between hello
time for default spanning tree.
stp set bridging hello-time
Specify the interval between hello
time for a particular instance of
spanning tree.
pvst set bridging spanning-tree
hello-time
Set the default of the forward delay
interval for default spanning tree.
stp set bridging forward-delay
Set the default of the forward delay
interval for a particular instance of
spanning tree.
pvst set bridging spanning-tree
forward-delay
Change the amount of time a bridge will
wait to hear BPDUs from the root bridge
for default spanning tree.
stp set bridging max-age
Change the amount of time a bridge will
wait to hear BPDUs from the root bridge
for a particular instance of spanning tree.
pvst set bridging spanning-tree
max-age