Cabletron Systems SmartSwitch - Manual (Page 117)

SmartSwitch Router User Reference Manual 117
Chapter 9: OSPF Configuration Guide
Configuring OSPF Interface Parameters
You can configure the OSPF interface parameters shown in the table below.
To configure OSPF interface parameters, enter one of the following commands in
Configure mode:
Table 4. OSPF Interface Parameters
OSPF Parameter Default Value
Interface OSPF State (Enable/Disable) Enable (except for virtual links)
Cost 1
No multicast Default is using multicast mechanism.
Retransmit interval 5 seconds
Transit delay 1 second
Priority 0
Hello interval 10 seconds (broadcast), 30 (non broadcast)
Router dead interval 4 times the hello interval
Poll Interval 120 seconds
Key chain N/A
Authentication Method None
Enable OSPF state on interface. ospf set interface <name-or-IPaddr> |all
state disable|enable
Specify the cost of sending a packet
on an OSPF interface. ospf set interface <name-or-IPaddr> |all
cost
Specify the priority for determining
the designated router on an OSPF
interface. ospf set interface <name-or-IPaddr> |all
priority
Specify the interval between OSPF
hello packets on an OSPF interface. ospf set interface <name-or-IPaddr> |all
hello-interval
Configure the retransmission interval
between link state advertisements for
adjacencies belonging to an OSPF
interface. ospf set interface <name-or-IPaddr> |all
retransmit-interval